packets. In case of anycast tunnel endpoints, the anycast
IP has to be used. In case of unicast endpoints, the
address is usually derived correctly from the routing
- table. The default is to not use a special inteface and just
+ table. The default is to not use a special interface and just
bind on all interfaces.
*-p, --port '<port>'*::
of multiple anycast hosts. The unicast IP address of
the anycast host can be used here. This is needed for
communication with the other anycast hosts. The default is to
- not use a special inteface and just bind on all interfaces. However
+ not use a special interface and just bind on all interfaces. However
this is only the case if synchronisation is active see *--sync-port*.
*-S, --sync-port '<port>'*::
the multiplex id to use. default: 0
*-s, --sender-id '<sender id>'*::
- Each anycast tunnel endpoint needs a uniqe sender id
+ Each anycast tunnel endpoint needs a unique sender id
(1, 2, 3, ...). It is needed to distinguish the senders
in case of replay attacks. This option can be ignored on
unicast endpoints. default: 0